Brand Information

A ShopRite® Brand

Preparation & Usage

Note: Do not cut plastic twist ties. Directions for Use: To Use: 1. Twist wringer handle to release mop head from locked position. Push wringer handle down towards the floor to spread mop head to begin mopping. 2. To wring out mop, slide wringer back into locked position. Hold the grip and twist the wringer in either direction towards the floor to squeeze out the water. Note: The more you twist, the more water you will squeeze out. Twist a little for wet mopping, twist more for damp mopping. To Remove the Mop Head: 1. Holding the mop head upwards, separate the mop head yarn to reveal the pole and the plastic connector at the top of the mop. 2. Remove the C-clamp pin near the top of the pole where the mop head attaches to the pole. Place C-clamp to the side for use with replacement head. Do Not Throw Away C-Clamp Pin! 3. Remove the connector of the old mop head from the pole and slide the head down the pole, removing head from wringer handle. Continue to slide the mop head down the pole until it is completely separated from the handle. Discard entire head. To Wash Mop Head: 1. Follow instructions above to remove the mop head. Place mop head in a net laundry bag. Machine wash mop head in cold water, separately. Air dry only. Do not use fabric softener or bleach. To Replace the Mop Head: 1. Slide replacement head from the bottom, up the pole, and into wringer handle, securing the bottom of the mop head to the wringer handle where the zip ties are located on the refill. Note: There are 4 small pins on the top of the wringer handle to keep the mop head in place. 2. Take the plastic connector at the top of the mop head and place it on top of the handle and align the holes to prepare for the C-clamp pin placement. 3. Secure C-clamp pin to lock in replacement head to the pole.

Features

For cleaning up your act

Non-scratch scrubber tip

Super absorbent microfiber head

Fine microfiber yarn digs deep into cracks and crevices