Product Detail

Excellent for: Roof Leaks, gutters, skylights, windowsills, flashings, duct work, foundations, awnings, chimneys, downspouts, vent pipes, A/C drip pans, RV's, campers, trailers, projects and so much more Flex Seal® is an easy to use rubberized coating that sprays out as a liquid, seeps into cracks and holes and dries to a watertight, flexible coating. Flex Seal® seals out water, air and moisture and helps prevent rust and corrosion. Once dry, Flex Seal® can be painted over. Flex Seal® is the easy way to coat, seal, protect and Stop Leaks Fast!

Brand Information

Phil Swift

Product Detail

Excellent for: Roof Leaks, gutters, skylights, windowsills, flashings, duct work, foundations, awnings, chimneys, downspouts, vent pipes, A/C drip pans, RV's, campers, trailers, projects and so much more Flex Seal® is an easy to use rubberized coating that sprays out as a liquid, seeps into cracks and holes and dries to a watertight, flexible coating. Flex Seal® seals out water, air and moisture and helps prevent rust and corrosion. Once dry, Flex Seal® can be painted over. Flex Seal® is the easy way to coat, seal, protect and Stop Leaks Fast!

Preparation & Usage

Directions: So Easy to Use! • Read entire can. Wear face and eye protection, protective gloves and clothing • Make sure the area is clean, dry and free of grease, oil and dirt. • Shake well: Spray 8” to 12" from surface using an even sweeping motion. • Apply several even coats until All cracks and holes have been filled. • Allow 24 to 48 hours to dry before applying another coat. Fully cures in 48 hours. Hint: Make sure Flex Sea has filled All Crack and Holes and is Fully Cured before testing product. If light passes through apply additional coats. Use only in a well ventilated area. Prevent vapor buildup by opening doors and windows. Ensure fresh air entry during application and drying. Do not use near heat, sparks, pilot lights or other sources of ignition. Do not smoke. When covering large areas indoors, eliminate ignition sources far from the point of use because vapors are heavier than air and may travel significant distances. When applying to large areas indoors, do not exceed use of 1/2 of a can before allowing one hour for the coating to dry and vapors to dissipate before using again. Works best at can temperatures above 60°F. Shake can throughout application. Note: After each use, invert can and apply a short burst to clear nozzle. Not intended for use by Professional Roofers. This product has not been tested for use in potable water systems. May not be compatible with all plastics and rubbers. To Open: Insert Screwdriver in Slot Pry Off by Pulling Up on Handle

Features

As Seen on TV

Liquid rubber in a can!

Stops leaks

Seals & protects

Covers easily